Week of 10/11

This week i started by spending some time on fusion 360 designing a raspberry pi case. I have already made one but it doesnt work with the new legs i printed for it and one of the parts also cracked. The new case is mainly going to be 3d orinted with some lasercut parts. This week i also started my install of a cybersecurity linux distro caleld blackarch. It is a 20gb os that is built on top of archlinux. Arm distros are what are needed to run on a raspberry pi and blackarch currently does not have a full arm package. I didnt know this and tried installing the full os wasting time downloading it. I then found out to make this work i had to build the blackarch repository on top of an arm supported archlinux version for the raspberry pi, getting past this issue. I installed linux to from there build my archlinux OS image on my separate sd card. I did this through the terminal which was new to me and a learning process Yesterday I also helped fellow classmate Nathaniel B. Mattarazzo with lasercutting.